How to use the Wavlink AX1800 setup. You can now bid your dead zones at home or at work a fond farewell thanks to the Wavlink AX1800 WN583AX1 WiFi repeater. It is a dual-band WiFi 6-mesh extender. It provides an 80 MHz bandwidth for increased efficiency and capacity. Following a successful Wavlink AX1800 setup, your current router’s range will be increased, allowing you to use the internet even in the farther-flung corners of your home or place of business.
1. When the power LED on the Wavlink AX1800 extender is stable, plug it in.
2. Connect your device to the Wi-Fi network of the extender.
3. Enter “ap.setup” in the address bar of an open web browser.
4. Enter the default qualifications, admin/admin, to log in.
5. To customise the extender settings, follow the on-screen instructions.
5. For better coverage, connect your devices to the extended Wi-Fi network.
1. Activate the Wavlink AX1800.
2. Position it close to the current modem/router.
3. Just press the WPS button on your WN583AX1.
4. Press the same button on your router now as well.
5. As soon as the WPS light turns green.
6. This indicates that your router and extender have successfully established a connection.
6. The booster can now be unplugged and placed in an area with dead spots.
Note:If you need any assistance regarding your Wavlink AX1800 Setup, get in touch with us via the chat button you see on the bottom right corner of this page.
1. Make a connection using the Wavlink AX1800 extender’s default wireless network.
2. Enter “ap.setup” in the address bar of an open web browser.
3. Enter the default qualifications, admin/admin, to log in.
4. Open the settings interface on the extender.
5. Change network settings as necessary..
6. To improve coverage, reconnect your devices to the expanded Wi-Fi network.
1. Turn on your WN583AX1 first.
2. Access any smart device.
3. Check out “ap.setup.”
4. After selecting Settings, select Firmware Upgrade.
5. To complete the firmware upgrade process, follow the instructions displayed on the screen.
6. The AX1800 should not be unplugged while the update is running.
1. Turn on your Wavlink AX1800.
2. Find the factory reset button inside a hole on your booster’s side panel.
3. Press the factory reset button for seven to ten seconds with a hard pin.
4. Your extender will automatically reboot and get ready for the first time once the LED begins to blink.
5. Remember not to unplug your extender until the procedure is finished.