The MSRM US750 Extender setup is very easy. Simply place it in a power outlet that is connected to your current WiFi network. Join the network of the extender, use the default IP address to reach the setup page in your browser, and then follow the on-screen directions to join your home WiFi. After it’s finished, take advantage of wider WiFi coverage in your house or place of business.
1. Apply power to the MSRM US750 Extender by plugging it in.
2. Link your device to the extender’s network.
3. Open a web browser and type in the given IP address by default.
4. For the username and password, use the normal settings.
5. To choose your home WiFi network, follow the on-screen directions.
6. When prompted, enter the WiFi password.
7. For best coverage, move the extender once it’s connected.
1. Close to your router, plug in the MSRM US750 Extender.
2. The WPS button on the extender should be pressed.
3. Press the WPS button for two minutes.
4. Watch for the WPS light on the extender to show that the connection was successful.
5. If necessary, move the extender to provide better coverage.
6. Enjoy increased WiFi coverage without changing any settings.
Note:If you need any assistance regarding your MSRM US750 wifi Extender, get in touch with us via the chat button you see on the bottom right corner of this page.
1. Link the device to the WiFi network of the MSRM US750 Extender.
2. Run a web browser.
3. In the address bar, type ap.setup or “192.168.0.1.”
4. Input your default username and password here.
5. To log in, press Enter.
6. Now that you’re signed in, you can change the settings of your extender as necessary.
1. Connect your device to the WiFi network of the MSRM US750 Extender.
2. Use a web browser.
3. In the address bar, type ap extender setup or “192.168.0.1.”
4. Enter your password and username to log in.
5. Find the settings menu’s “Firmware Update” section.
6. To download and install the most current firmware update, follow the on-screen steps.
1. Find the MSRM US750 Extender’s reset button.
2. Hold down the reset button for approximately ten seconds.
3. When the extender’s lights begin to blink, release the reset button.
4. Check for the reboot and factory reset of the extender.
5. Change the settings on your extender as required.