Connect in your Victony WA305 Extender Setup, join its WiFi network, then open a web browser to “ap.setup” to set it. After choosing your current WiFi network and logging in using the default credentials, you’re done. Enjoy smooth access to wider WiFi coverage.
1. Wait for the LED to turn on after plugging in the Victony WA305 Extender.
2. Connect the device to the WiFi network of the extender.
3. Open a browser, then enter “ap.setup”.
4. Use the default login information, which is often “admin” for both the username and password.
5. To choose an already-existing WiFi network and enter a password, follow the on-screen instructions.
6. Extender has been set up and prepared for increased coverage.
1. After connecting in the Victony WA305 Extender, watch for the LED to stabilise.
2. Click the WPS button located on the extender.
3. Press the WPS button on your router after two minutes.
4. Wait for the extender’s WPS LED solid.
5. Use the default SSID and password to connect to the extended network.
6. Take advantage of hassle-free expanded WiFi coverage.
Note: If you need any assistance regarding your Victony WA305 extender, get in touch with us via the chat button you see on the bottom right corner of this page
1. Make a WiFi connection using the Victony WA305 Extender.
2. Enter “ap.setup” in the address bar of an open web browser.
3. Use the standard username and password to log in, which are usually “admin” for both.
4. Go to the setup options and settings of the extender.
5. Adjust the settings if needed to get the best results.
1. Join the network of the Victony WA305 Extender.
2. Enter “ap.setup” in the address bar of an open web browser.
3. You can log in by entering your password and username.
4. Find the option for firmware updates by going to the settings menu.
5. Go to the Victony website to download the most recent firmware.
6. Using the interface on the extender, upload and install the firmware upgrade.
1. Make sure the LED indications are on and the extender is powered on.
2. Verify that your device is connected to the extender’s network.
3. Reconnect devices to the network and give the extender a restart.
4. Inspect the space between the extender and router for any physical impediments.
5. If problems continue, follow the directions in the handbook to do a factory reset.
1. Find the Victony WA305 Extender’s reset button.
2. Hold down the reset button for approximately ten seconds.
3. As soon as the LED indicators begin to flash, release the reset button.
4. Wait for the reboot and factory reset of the extender.