apsetupusa.online

wavlink wifi extender setup

Wavlink AC3000 Setup

Your Wavlink AC3000 setup is easy and requires no hassles. Start by using an Ethernet wire to connect your modem and router. Turn on the router and watch for a stabilisation of the LED lights. Use the default IP address to access the router’s settings page in a web browser. To alter network name and password settings, follow the on-screen instructions. Once set up, you may have dependable, quick Wi-Fi connectivity throughout your house or place of business. Consult the included user manual for information on advanced features and troubleshooting.

Wavlink AC3000 Extender Setup-Manual Guide

  • Connect the Wavlink AC3000 Extender to a power source that is close to your router.
  • A solid green power LED will not turn on until you wait.
  • On your device, join the “Wavlink-Ext” Wi-Fi network.
  • Go to “ap.setup” in the address bar of a web browser.
  • Enter “admin” as your username and password to log in.
  • To modify the extender parameters, follow the on-screen guidelines.
  • For improved coverage, connect your devices to the expanded Wi-Fi network after it has been configured.

 

Note: If you need any assistance regarding your Coredy wifi extender, get in touch with us via the chat button you see on the bottom right corner of this page.

Wavlink AC3000 Extender Setup-WPS Guide

  • Start your Wavlink AC3000 Extender by pressing the WPS button.
  • Press your router’s WPS button within two minutes.
  • Wait for the solid green LED on the extender to turn on.
  • Connect your devices to the Wi-Fi network that is extended.
  • Enjoy easy access to wider Wi-Fi coverage.
  • Passwords are not needed; it’s that easy!

 

Wavlink AC3000 Extender Firmware Update

  • Use a browser to access the web interface of the Wavlink AC3000 Extender.
  • Go to the region for firmware updates.
  • Get the most current firmware by visiting the Wavlink website.
  • To the extender, upload the firmware file.
  • Start the process of updating the firmware.
  • To get better performance, wait for the upgrade to complete and the extender to reboot.

 

Login Steps Wavlink AC3000 Extender

Reset Wavlink AC3000

  • Connect the Wi-Fi network of the Wavlink AC3000 Extender to your device.
  • In the address box of an open web browser, type “ap.setup” or “192.168.0.1.”.
  • After entering “admin” for the password and username, click “Login.”
  • To view the extender’s settings, follow the on-screen directions.
  • Change network name and password settings as required.
  • To make changes take effect and finish the login process, click “Save.”

 

  • Check for the Wavlink AC3000 extender’s reset button.
  • Use a paperclip or other similar item to press and hold the reset button for approximately ten seconds.
  • As soon as the LED lights begin to flash, release the reset button.
  • Wait for reboot and reset of the extender.