apsetupusa.online

wavlink wifi extender setup

MSRM Wifi Extender Setup

Your MSRM WiFi extender setup is simple and quick to set up. To use it, just put it into a power outlet, join its WiFi network, use a web browser, and type in the IP address by default. To configure the extender settings, log in using the default username and password and follow the on-screen instructions. Your MSRM us300 extender will increase WiFi coverage in locations with weak signals once it is configured.

MSRM Wifi Extender Setup

MSRM Wifi Extender Setup-WPS Guide

MSRM Wifi Extender Setup-Manual Guide

  1. Place the MSRM WiFi extender next to your router after plugging it in.
  2. The extender WPS button should be pressed.
  3. Press the WPS button for two minutes.
  4. Await the extender’s WPS LED to solidify and cease flashing.
  5. If you need better coverage, move the extender.
  6. Right now, your MSRM WiFi extender is configured with WPS.
  • Connect to the network of the MSRM WiFi extender by plugging it in.
  • Launch a web browser and type in 192.168.10.1 or ap.setup by default.
  • Use the default login information, which is often “admin” for both the username and password.
  • To choose and expand your WiFi network, adhere to the on-screen directions.
  • If necessary, apply the settings and watch for the extender to reboot.
  • To make sure WiFi is covered in large regions, check the strength of the signal.

 

Note: If you need any assistance regarding your MSRM WIFI RANGE EXTENDER, get in touch with us via the chat button you see on the bottom right corner of this page.

How do I login to MSRM Wifi Extender?

How do I update the MSRM US300 Extender firmware?

  • Connect to the WiFi network of the MSRM extender.
  • Launch a web browser.
  • In the URL bar, type 192.168.10.1 or ap setup by default.
  • If asked, log in with the default password and username.
  • Go to the login screen.
  • Put in your credentials.
  • As of right now, MSRM WiFi Extender is open to you.

 

  • Get the most recent firmware for your extender by visiting the MSRM website.
  • Link into the WiFi network of the extender.
  • Launch your internet browser and type the IP address by default.
  • Navigate to the settings page of the extender.
  • Go to the area for firmware updates.
  • Upload the firmware file that you downloaded.
  • Complete the directions on the screen to complete the change.
  • When the update is finished, wait and, if needed, reboot the extender.

 

MSRM Wifi Extender Reset

  • Go to the MSRM WiFi extender’s reset button.
  • For 10 to 15 seconds, hold down the reset button.
  • When the LED lights begin to blink, release the reset button.
  • Await the reboot and factory reset of the extender.
  • Adjust the settings of your extender as necessary.
  • Resetting your MSRM WiFi extender was successful.